Configure Ethernet Settings

The Ethernet settings allow the iPad and the Fiesta iOS App to communicate with Guac’s LED Ring and the connected printer.

These settings are required to run an event with Guac.

---

Table Of Contents

Before You Start

• Install the iPad into Guac

How To

• Configure Ethernet Settings

Next Step

• Assemble Guac

---

Before You Start

Install The iPad Into Guac

Installing the iPad is required before configuring the Ethernet settings. The Ethernet settings will not appear on the iPad if it is not plugged into the booth.

Guac does not need to be powered on in order to access the Ethernet settings.

If you haven’t installed the iPad yet, you can find the iPad Installation Guide here.

---

How To

Configure Ethernet Settings

View fullsize

1. Open the iPad Settings app

2. Tap Ethernet in the left navigation

3. Tap USB 10/100/1000 LAN

4. Tap Configure IP

5. Select Manual

6. Tap IP Address

7. Enter in 172.16.0.7

8. Tap Subnet Mask

9. Enter in 255.255.255.0

10. Tap Save

Note: After tapping Ethernet your iPad may show AX88179A Instead of USB 10/100/1000 LAN

---