How to Set up the Guac LED Ring
Connect to Guac’s LED ring and and customize the brightness, color, and patterns to match your event’s branding.
Table of Contents
Step One
Assemble and Power on Guac
Install the Canon camera and iPad into Guac
Assemble the base plate, poles, and Guac head
Plug Guac into power to turn it on.
Note: If you haven’t completed these steps previously, you can view the full Guac Assembly Guide here.
Step Two
Configure Ethernet Settings
Open the Settings app on the iPad
Tap Ethernet in the left navigation
Tap Configure IP
Select Manual
Tap IP Address
Enter in 172.16.0.7
Tap Subnet Mask
Enter in 255.255.255.0
Tap Save
Note: If you’ve previously configured the Ethernet settings, you won’t need to again.
Step Three
Customize the LED Ring
Open the Salsa iOS app
Select an event or create a new event
Tap the Settings gear
Tap Guest Interface
Tap Branding LEDs
Select either Solid Mode or Pattern Mode
Select an accent color or pattern for your event
What To Know
Changing the LED Ring from the Web App
The LED ring color, pattern, and brightness can be adjusted from the web app at any time – even if Guac isn’t plugged in and powered on.
Any changes made within the Event Settings on the web app will be saved to the event.
As soon as the iPad is powered on, connected to Wi-Fi, and the Salsa iOS app is opened, those changes will be sent over to the iPad and the event settings will be applied.
If Guac is powered on and the iPad is connected to Wi-Fi with the event is running, those changes will be applied immediately.
