Tortilla Disassembly

Packing up after an event has never been simpler. Tortilla is not only easy to set up, it’s easy to take down — disassemble Tortilla in just a few short steps using the guide below.

---

Step One

Unplug and Remove Accessories

1. Unplug the AC power cable from the power outlet

2. Remove tape from cable

3. Remove iPhone from iPhone mount

4. Remove iPhone mount from universal mount on Tortilla arm

---

Step Two

Remove the Tortilla Arm

1. Loosen universal mount hinge screw and tilt toward the Tortilla base

2. Tighten universal mount hinge screw

3. Loosen the arm knob and slide arm down fully; tighten arm knob

4. Adjust hinge angle back to 90* by unscrewing and pulling out the hinge knob

5. Compress the pin lock, and slide the Tortilla arm off of the Tortilla base

6. Set the Tortilla arm aside

   Note: do not pack the Tortilla arm yet

---

Step Three

Unplug Tortilla and Pack

1. Remove the DC power supply from underneath the Tortilla base

2. Unplug the AC power cable from the DC power supply

3. Unplug the DC power supply from the Tortilla base

4. Set aside both power cables

5. Unzip the large compartment in the Tortilla case

6. Lift the Tortilla base onto the side panel

7. Roll the Tortilla base along the side panel into the case

---

Step Four

Pack the Tortilla Arm

1. Confirm the Tortilla arm hinge is at 90*

2. Slide the Tortilla arm into the case underneath the Tortilla base

   Note: the end with the universal mount goes in first

3. Rotate to make sure the arm is pointed upward

4. Zip the side panel closed

---

Step Five

Pack the Accessories

1. Wrap the AC power cable

2. Unzip the small compartment side panel

3. Insert the AC power cable, DC power supply, iPhone mount, and remote

   Note: Make sure the AC power cable is unplugged from the DC power supply

4. Zip the side panel closed

---