Step One
Unplug and Remove Accessories

1. Unplug the AC power cable from the power outlet
2. Remove any tape from the cable
3. Remove the iPhone from the iPhone mount
4. Detach the iPhone mount from the universal mount on the Tortilla arm

Back to top

Step Two
Remove Tortilla Arm

1. Loosen universal mount hinge screw and tilt the arm toward the Tortilla base
2. Tighten universal mount hinge screw
3. Loosen the arm knob and slide the arm fully downward; then tighten the arm knob
4. Adjust hinge angle back to 90° by unscrewing and pulling out the hinge knob
5. Compress the pin lock and slide the Tortilla arm off the Tortilla base
6. Set the Tortilla arm aside
   
   IMPORTANT: Do not pack the Tortilla arm yet

Back to top

Step Three
Unplug Tortilla And Pack

1. Remove the DC power supply from underneath the Tortilla base
2. Unplug the AC power cable from the DC power supply
3. Unplug the DC power supply from the Tortilla base
4. Set aside both power cables
5. Unzip the large compartment in the Tortilla case
6. Lift the Tortilla base onto the side panel
7. Roll the Tortilla base along the side panel into the case

Back to top

Step Four
Pack The Tortilla Arm

1. Confirm the Tortilla arm hinge is at 90°
2. Slide the Tortilla arm into the case underneath the Tortilla base
   Note: Place the universal mount end first
3. Rotate the arm so it points upward
4. Zip the side panel closed

Back to top

Step Five
Pack Accessories

1. Wrap the AC power cable
2. Unzip the small compartment side panel
3. Insert the AC power cable, DC power supply, iPhone mount, and remote
   Note: The AC power cable must be unplugged from the DC power supply
4. Zip the side panel closed

Back to top