Before You Start

Before assembling the Tortilla 360 Booth, complete these preparations:

• Update to the latest iOS version
• Have a 13-foot (4m) diameter circular area to set up the Tortilla Booth (approximately 13' x 13'/4m x 4m)
• Have a photo booth attendant

IMPORTANT: An attendant must start each capture and guide guests onto the platform. Tortilla uses the iPhone rear camera, so guests cannot see a Tap to Start screen while standing on the platform.

Back to top

Step One
Unpack Tortilla

1. Roll the Tortilla 360 Booth case to a position behind where the booth will be fully set up
2. Unzip the large side panel
3. Remove the Tortilla arm and set aside
   Note: The Tortilla arm must be removed before the base
4. Roll the Tortilla base out along the side panel
5. Lay the Tortilla base down on the floor, feet side first

Back to top

Step Two
Balancing Tortilla

1. Begin by standing on the Tortilla platform with a wide stance, placing each foot on opposite edges of the base
2. Shift weight gently from side to side, as well as forward and backward, to become familiar with the movement of the base
3. Adjust foot placement as needed to maintain balance and ensure the Tortilla base remains stable

Back to top

Step Three
Attach The Arm

1. Compress the pin lock on the Tortilla arm attachment point on the base
2. Slide the Tortilla arm onto the Tortilla arm attachment point
3. Adjust the arm angle by unscrewing and then pulling out the hinge knob
4. Extend the arm by unscrewing the arm knob and sliding the arm up and down
5. Secure both the arm knob and the hinge knob to lock the angle and height in place

Back to top

Step Four
Attach iPhone

1. Loosen the universal mount hinge screw to adjust angle, then tighten
2. Attach iPhone mount to the universal mount using the universal screw knob
3. Loosen iPhone mount side grips
4. Slide the iPhone into place with the rear camera facing inwards towards the Tortilla platform
5. Re-tighten iPhone mount side grips

Note: Make sure not to over-tighten the side mounts, as that can trigger the iPhone emergency call system

Back to top

Step Five
Attach The Power Cables

Connect the AC power cable to the DC power supply. Then:

1. Plug the DC power supply into the DC socket that is below the Tortilla platform
   Note: Do not plug the AC power cable into the power outlet yet
2. Position the DC power supply in the opening under the Tortilla base

Back to top

Step Six
Plug The Power Cable In

1. Locate the power outlet to plug the Tortilla Booth in to
2. Tape down the AC power cable
   Note: Do this before plugging the Tortilla Booth into power
3. Plug the AC power cable into the power outlet to turn on Tortilla
4. Test Tortilla by using the remote to start rotation

Back to top