Walkthrough
How To
What To Know
Installing Your iPad
In this video, you will learn:
- How to remove the Salsa 2 Faceplate
- How to insert the iPad properly
- How to secure the Salsa 2 Faceplate in place
Install Your iPad Into The Salsa 2
- Remove the Salsa 2 Head from the case
- Open the Salsa 2 Head using the Roamer Release lever
- Remove the Roamer from the Salsa 2 Head
- Remove the Roamer Handle from the Roamer if it is attached
- Place the Salsa 2 Roamer face-up on a flat surface
- Using the Hex Wrench included, unscrew the screws holding the faceplate
- Lift the Faceplate to remove it and set it aside
-
Remove the Cardboard insert and store in the Salsa 2 case
Note: Do NOT throw away cardboard insert - Plug the USB-C Extender into the iPad
- Place the iPad in the center of the foam pads
- Situate the Faceplate over the iPad
- Secure the Faceplate into place over the iPad
And you are done! You can now attach your Salsa 2 Roamer to the Salsa 2 head, or replace the Salsa 2 Roamer handle to use as a roamer booth for your event.
Next Steps
Once you have your iPad installed into the Salsa 2 booth, you can proceed to pair your LEDs and start creating your Fiesta events!