The Tortilla Booth is designed to be our easiest to set up booth yet. Within a few minutes, you will have your booth assembled and ready to go.
Before You Start
Before assembling the Tortilla Booth, make sure you:
- Update to the latest iOS version
- Have a 13 foot (4m) diameter circular area to set up your Tortilla Booth (approximately 13' x 13'/4m x 4m)
- Have a photo booth attendant
IMPORTANT: It is expected to have an attendant present at 360 events to initiate a capture using Tortilla, and to guide guests to the platform during the event. Tortilla uses the back camera of the iPhone meaning guests will not see the Tap To Start Screen when standing on the Tortilla platform.
Part One
Unpack Tortilla
- Roll the Tortilla case to a position behind where your booth will be fully set up
- Unzip the large side panel
-
Remove the Tortilla arm and set aside
Note: The Tortilla arm must be removed before the base - Roll the Tortilla base out along the side panel
- Lay the Tortilla base down on the floor, feet side first
Part Two
Balance Tortilla
- Step onto the Tortilla platform and place your feet in a wide stance. Each foot should be on the edge of the base, across from each other.
- Shift your weight from side to side, forward and backward
- Adjust the feet as necessary to balance the Tortilla base
Part Three
Attach The Arm
- Compress the pin lock on the Tortilla arm attachment point on the base
- Slide the Tortilla arm onto the Tortilla arm attachment point
- Adjust the arm angle by unscrewing and then pulling out the hinge knob
- Extend the arm by unscrewing the arm knob and sliding the arm up and down
- Secure both the arm knob and the hinge knob to lock the angle and height in place
Part Four
Attach iPhone
- Loosen the universal mount hinge screw to adjust angle, then tighten
- Attach iPhone mount to the universal mount using the universal screw knob
- Loosen iPhone mount side grips
-
Slide iPhone into place and re-tighten side grips
Note: Make sure to not over-tighten the side mounts as that can trigger the iPhone emergency call system
Part Five
Attach The Power Cables
Connect the AC power cable to the DC power supply. Then:
-
Plug the DC power supply into the DC socket that is below the Tortilla platform
Note: Do not plug the AC power cable into the power outlet yet - Position the DC power supply in the opening under the Tortilla base
Part Six
Plug The Power Cable In
- Locate the power outlet you will be using
-
Tape down the AC power cable
Note: Do this before you plug the Tortilla Booth into power - Plug the AC power cable into the power outlet to turn on Tortilla
- Test Tortilla by using the remote to start rotation