Packing up after an event has never been simpler. Tortilla is not only easy to set up, it’s easy to take down — disassemble Tortilla in just a few short steps using the guide below.
Step One
Unplug and Remove Accessories
- Unplug the AC power cable from the power outlet
- Remove tape from cable
- Remove iPhone from iPhone mount
- Remove iPhone mount from universal mount on Tortilla arm
Step Two
Remove the Tortilla Arm
- Loosen universal mount hinge screw and tilt toward the Tortilla base
- Tighten universal mount hinge screw
- Loosen the arm knob and slide arm down fully; tighten arm knob
- Adjust hinge angle back to 90* by unscrewing and pulling out the hinge knob
- Compress the pin lock, and slide the Tortilla arm off of the Tortilla base
-
Set the Tortilla arm aside
IMPORTANT: Do not pack the Tortilla arm yet
Step Three
Unplug Tortilla and Pack
- Remove the DC power supply from underneath the Tortilla base
- Unplug the AC power cable from the DC power supply
- Unplug the DC power supply from the Tortilla base
- Set aside both power cables
- Unzip the large compartment in the Tortilla case
- Lift the Tortilla base onto the side panel
- Roll the Tortilla base along the side panel into the case
Step Four
Pack the Tortilla Arm
- Confirm the Tortilla arm hinge is at 90*
-
Slide the Tortilla arm into the case underneath the Tortilla base
Note: the end with the universal mount goes in first - Rotate to make sure the arm is pointed upward
- Zip the side panel closed
Step Five
Pack the Accessories
- Wrap the AC power cable
- Unzip the small compartment side panel
-
Insert the AC power cable, DC power supply, iPhone mount, and remote
Note: Make sure the AC power cable is unplugged from the DC power supply - Zip the side panel closed