How To Set Up The Guac LED Ring

Connect to Guac’s LED ring and customize the brightness, color, and patterns to match your event’s branding.

Table Of Contents

Steps

• Step 1: Assemble and Power on Guac 

• Step 2: Configure Ethernet Settings

• Step 3: Customize the LED Ring
  
  

What To Know

• Customizing the LED Ring on the Web App
  
  

Step One

Assemble And Power On Guac

1. Install the Canon camera and iPad into Guac
2. Assemble the base plate, poles, and Guac head
3. Plug Guac into power to turn it on.
   
   

Note: If you haven’t completed these steps previously, you can view the full Guac Assembly Guide here.

Back to top

Step Two

Configure Ethernet Settings

1. Open the Settings app on the iPad
2. Tap Ethernet in the left navigation
3. Tap Configure IP
4. Select Manual
5. Tap IP Address
6. Enter in 172.16.0.7
7. Tap Subnet Mask
8. Enter in 255.255.255.0
9. Tap Save
   
   

Note: If you’ve previously configured the Ethernet settings, you won’t need to do this again.

Back to top

Step Three

Customize The LED Ring

1. Open the Fiesta iOS app
2. Select an event or create a new event
3. Tap Configure Event
4. Tap Interface
5. Tap LED Ring
6. Select either Solid Mode or Pattern Mode
7. Select an accent color or pattern for your event
   
   

Back to top

What To Know

Changing The LED Ring From The Web App

The LED ring color, pattern, and brightness can be adjusted from the Fiesta Web App at any time – even if Guac isn’t plugged in and powered on.

Any changes made within the Event Settings on the web app will be saved to the event.

As soon as the iPad is powered on, connected to Wi-Fi, and the Fiesta iOS App is opened, those changes will be sent over to the iPad and the event settings will be applied.

If Guac is powered on and the iPad is connected to Wi-Fi with the event is running, those changes will be applied immediately.

Back to top

Warning: Do not run the Salsa App and Fiesta software simultaneously. Doing so will prevent the LEDs from pairing.