Learn how to properly set up your Salsa 1 Booth as the foundation for running amazing events.
Step one
Preparing Your iPad
- Make sure your iPad is up to date with the latest software version
- Sign up for your Fiesta account
- Download, install, and sign into the Fiesta iOS App
- Optimize your iPad settings
Note: For information on purchasing an iPad for your Salsa 1 Booth, check out our article here.
Step Two
Install the iPad into the Salsa 1 Head
- Using the included Philips screwdriver, remove the four screws from the Salsa 1 faceplate, and remove the faceplate
- Plug the power cable into the iPad and place it inside the Salsa 1 head unit
-
Place the faceplate back onto Salsa 1 and screw it into place
Note: Install the screws in a cross pattern (top left, bottom right, top right, bottom left) and make sure not to over-tighten the screws.
IMPORTANT: Do not use power tools when screwing in the face plate.
Salsa 1 comes with the 12.9" 3rd/4th Generation iPad Pro faceplate pre-installed. You can purchase an alternative faceplate here if you have a different iPad.
Step Three
Assembling Booth Base Plate and Poles
- Place base plate with longer half facing away from the backdrop
- Run the DC extension cable under base plate and through the hole (about two arms length)
- Run the DC extension cable through the first pole and place it onto the base plate
- Tighten both knobs at the same time to until they are finger tight
- Slightly loosen the knobs to adjust them into an X shape, matching the sticker
- Repeat steps 3, 4, and 5 for the second pole
Step Four
Attach the Salsa Head
- Carefully lift the Salsa 1 head and plug the DC extension cable into the bottom of the Salsa head
- Tighten the screw around the end of the DC extension cable to secure it in place
- Place the Salsa 1 head on top of the pole
- Tighten the two knobs at the same time until it is securely in place
- Loosen the tilt lever on the back of the Salsa 1 head to adjust the tilt
- Tighten the tilt lever once you have adjusted it to your needs
Step Five
Connecting Power
- Connect the other end of the DC extension cable into the power supply
- Plug the AC power cable into the power supply
- Plug the AC power cable into a wall outlet
IMPORTANT: Always have an iPad installed or fan covered before turning the booth on! Turning your booth on without the iPad installed can cause damage to the internals of your booth.
Please note your warranty will be void if Salsa 1 is powered on without an iPad or the insert installed.
You can also use the cardboard insert instead of the iPad. Don’t throw this away!